[TowerTalk] Calculating Forces for Tilting tower
n8de at thepoint.net
n8de at thepoint.net
Wed May 29 09:55:32 EDT 2019
The tower will have its mass concentrated at the 20' level, and the 50
lbs 'at the top' will have its mass concentrated at the 40'+ level.
if the 'hinge' is at ground level and your winch is at the 10' level,
the total force of those two loads will be:
2x the tower load PLUS
4x the 'top' load.
that's quite a bit for the position of the winch .. AND .. if the
winch is connected to the garage, it just might pull the garage wall
down.
73
Don
N8DE
Quoting Dave Tipton <dave at w5dmt.com>:
> I have a 40 foot Rohn 25, with a tilt base section. It will be
> sitting next to a detached framed (not block) garage with siding.
>
> I can attach a winch to an extra guy bracket I have at the ten foot level.
>
> There will be roughly 50 lbs at the top of the tower. (Rotator, Hex
> Beam, GP3)
>
> How much is the maximum force required to raise this from a cable at
> the 10 foot level?
>
> Thanks,
> Dave, W5DMT
>
> Sent from my iPhone
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
More information about the TowerTalk
mailing list