[TowerTalk] EHS leads for Phillystran

[Steve Maki]

It *disconnects* the preforms from the tower legs.

I must say I'm surprised that this action was needed when talking about 
40 meters, but if one wants perfection, and sees SWR changes with 
antenna rotation, then it's needed, no doubt about it.

-Steve K8LX

On 10/02/19 20:42 PM, Keith Dutson wrote:

> So this arrangement moves the preform away from the tower leg?  I am
> rebuilding my tower and have three TIC rings mounted about 4 feet above the
> guy mounts.


> I had a problem with just Preforms attaching to the tower legs connection -
> which caused distortion in the pattern of close mounted Yagi's. That is,
> Yagi's that were mounted only a few feet above a guy connection point. The
> VSWR of the affected Yagi would change with rotation and the effect of three
> Preforms connected to the tower was confirmed with modeling. The solution
> was to use a bent pin shackle and an insulator right at the tower
> connection. You can see it in this view of the middle four element 40 meter
> OWA Yagi stack at K3LR:
> http://www.k3lr.com/2016/ring.jpg
> 
> Using insulators at the tower connection completely solved the pattern
> distortion and VSWR changes with rotation.