[TowerTalk] Yaesu G-2800 problem with new unit

[W3YY]

Al -

I have the same setup, G-2800DXA and RT-21D.  The other suggestions offered
for solving your problem look good.

Here are some things you've probably done, but I'll ask anyway.

Have you confirmed that your brand new RT-21 has been internally configured
for use with the G-2800?

Did you initially go through the setup and calibration procedure for the
RT-21 with the G-2800?

Good luck.  My G-2800 and RT-21D have been successfully turning my 2-el 40M
beam at 120ft for more than a decade.  The GH controller and G-2800 are a
great combination and I hope you get it working. 

73, Bob - W3YY


-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of
al.n6ta at gmail.com
Sent: Saturday, September 07, 2019 7:55 PM
To: towertalk at contesting.com
Subject: [TowerTalk] Yaesu G-2800 problem with new unit

I hooked up my brand new RT-21 Green Heron controller to a brand new G-2800.
On the ground thru the final cable.

The rotor will not turn and the GH controller says Error No Motion.  Lots of
checks and the motor winding is open, pins 4 and 5 on the rotor itself.

Upon initial test, I had no idea where the rotor was in its range.  The
RT-21 said 263 when it was turned up while being connected to the rotor.  I
used the point and shoot knob and set it to about 180 deg, the end of travel
limit, I believe.  While watching the rotor from 20' away, I saw it move
momentarily.  It has not moved since.

 

Looking at the documentation, I assume that the limit switches in the
rotator are open in some way that will not allow current to the motor.  Or,
that there is an internal wire failure or the filter unit PCB in the rotor
has an open.

I note that the internal potentiometer is at end of range at 500 ohms as
measured from pins 1 to 2 and 1 to 3 of the rotor.  Pins 2 to 3 is
essentially a short.

I believe the RT-21 is working fine and all the cable and connectors have
been checked till I am sick of testing!

 

I am hoping someone has some experience with this such that I can get it
going.    

 

Al

N6TA

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk