[TowerTalk] Crimp Connector Tool
Jim Brown
jim at audiosystemsgroup.com
Wed Jan 8 22:46:37 EST 2020
Thanks Paul. Yes, Danny is a smart guy.
73, Jim K9YC
On 1/8/2020 12:43 PM, Paul Christensen wrote:
> Jim,
>
> I'm not normally one for going against a manufacturer's assembly
> instructions, but K6MHE's installation method with a reducer is vastly
> superior to that suggested by Amphenol. It works especially well with
> RG-400 and silver-plated UG reducers. This method has been posted to the
> list in the past but newcomers may have an interest. Try just one and see
> if you can't stop making more.
>
> Installation is even easier when a bench vise is available. Insert the
> cable into the vise straight up and adjust the cable so that when the
> reducer slides on, it rests on top of the jaws, making soldering a snap.
> With this method, even the cable cutting dimensions are less critical.
>
> https://www.zaarc.org/PL-259_w_reducer_Assembly.pdf
More information about the TowerTalk
mailing list