[TowerTalk] 4 square question

[Alan Swinger]

Per my DX Eng Guide used to construct my 40M 4 Sq and in daily use, radiation is on the diagonals . .. not broadside. - Alan K9MBQ


-----Original Message-----
>From: kq2m at kq2m.com
>Sent: Oct 18, 2020 2:49 PM
>To: towertalk at contesting.com
>Subject: [TowerTalk] 4 square question
>
>Hi,
>
>I will be rebuilding several 4-squares this season as well as restringing them in different trees due to Tornado damage (loss or destruction of many trees at my qth) during Tropical Storm Isaias on August 4th.  I have a few questions for which I would appreciate your guidance....
>
>1) If I recall correctly, for purposes of focusing on Europe, ideally I would want to put the 4 elements in a box formation in the NE, SE, SW and NW directions relative to the middle of the array.  Is that correct?
>
>2) In the 4-square when I select the controller direction NE, I am effectively radiating broadside NE from the NW and SE elements.  Is that correct?
>
>3) In the past I had the bottom of the 4-square elements soldered to center conductor of the pin of an SO239 with the radials attached to each of the SO239 screw holes, with the coax connector for the phasing line screwed onto the SO239.   (The choke was located below the PL259 on the phasing line) This worked well but I am trying to improve the design.
>
>If I were to terminate the bottom of the 4-square element by twisting it through and around one hole of the porcelain insulator and soldering it there, would I still be able to then solder a small wire from that connection to the center conductor pin of a SO239 with the radials attached to the SO239 screw holes as before?  My idea being that I can do that then I can use a piece of twine through the remaining porcelain insulator hole taped to the coax to provide additional physical support for the coax and radials – which will be helpful during ice storms.
>
>I would appreciate any thoughts and suggestions and possible improvements on this design.
>
>Tnx  & 73
>
>Bob, KQ2M
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk at contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk