[TowerTalk] Ham IV part identificaiton

[kj6y at aol.com]

I tried all over the internet to find those screws. I did get some from Hygain/MFJ.  I had a brand new Ham IV on an MA-40 mounted on top and the screws holding the top and bottom pieces together came loose and the antenna fell off.  Screws were not put on with Locktite.  Sent back to Hygain for replacement.  They replaced the top half and installed new screws.  Again no Locktite. I removed and reinstalled the screws with Locktite.  Hopefully this will keep it from happening again.  All the rotors I refurbish I use Locktite on the screws.   Skip Bolnick, KJ6YCommunications Service Cowww.kj6y.com818-522-5421  In a message dated 2/9/2021 8:19:30 AM Pacific Standard Time, marvs at att.net writes: 
Does anyone know what size bolt is used to hold the upper bell housing to the lower housing in a Ham IV?  Marv K7IU_______________________________________________   _______________________________________________TowerTalk mailing listTowerTalk at contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk