[TowerTalk] Dummy Load

[Wes]

You can measure the load with an ohmmeter.  If it's open or measures too high, 
check the four screws that center the bottom of the load resistor in the shield 
for tightness.

Wes  N7WS


On 7/27/2021 1:56 PM, JOHN OWENS wrote:
> It is pretty clear that my Heathkit Dummy load is Dead. I need to measure my FTDX-101MP output on 6M (<200w) just to verify it is working as it should, before I start tearing into my 5el 6M beam installation. Help would be appreciated. I live in Edmonds , N of downtown Edmonds.
>
> John Owens -   N7TK
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk