[TowerTalk] Disassembling TIC 1022B
Al Kozakiewicz
akozak at hourglass.com
Tue Mar 23 15:34:15 EDT 2021
Gear puller. If it is tight enough to require heat for extraction, I find that a propane torch does not generate enough differential heating between the part you want to remove and the thing it is stuck to. Need oxy-acetylene, but that will quickly ruin the temper on hardened parts, so you only do that when you know the part isn't hardened or you are desperate. And also where the heat won't damage something like a motor or bearing.
Al
-----Original Message-----
From: TowerTalk <towertalk-bounces at contesting.com> On Behalf Of Steve London
Sent: Tuesday, March 23, 2021 3:26 PM
To: towertalk at contesting.com
Subject: [TowerTalk] Disassembling TIC 1022B
I am trying to repair a well-used TIC 1022B.
I need to separate the gear assembly from the motor. The keyed gear that slides on to the motor shaft is stuck. I have removed the screw on top of the gear, and I don't see any set screws. Tried some WD-40. Is there any trick before I use a propane torch on it ?
73,
Steve, N2IC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list