[TowerTalk] Rohn TB-3 thrust bearing

[Mpridesti]

Got the call from Tim at Rohn

ID is 2.06 inches

Thanks again for the help!  Great group here!

Regards,

Mark, K1RX


> On May 26, 2021, at 10:55 AM, Stan Stockton <wa5rtg at gmail.com> wrote:
> 
> 
> Said to accept maximum of 2 inch OD so has to be a few thousandths over that. You couldn't even fit a 1.5 inch schedule 40 pipe through it if 1-7/8.
> 
> Stan, K5GO
> 
>> On Wed, May 26, 2021, 9:03 AM CEPitts <cpitts at ec.rr.com> wrote:
>> Hi Mark my small metal caliper measures at 1 and 7/8" or 27mm....if it is off it only by 1mm according to my handy little caliper. If others respond hopefully they confirm what I have provided. Charle4s "Ed" K5OF in NC
>> 
>> Hello group!
>> 
>> Could someone here give me the precise inside diameter of this bearing? Quick
>> checks in the Rohn catalog (over 230 pages) I was unable to find it.
>> 
>> Thanks!
>> 
>> Regards,
>> 
>> Mark, K1RX
>> 
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk