[TowerTalk] Kellums Grip for supporting cables aat tower top

[chris perri]

Coax arms with a top curved arm to act as a strain relief.  This a a lot easier to swap out cables and troubleshoot down the road.

https://www.kf7p.com/KF7P/CoaxArms.html <https://www.kf7p.com/KF7P/CoaxArms.html>

Chris
KF7P



> On Oct 7, 2021, at 11:59 AM, al.n6ta at gmail.com wrote:
> 
> I know what they are and do not need one for pulling thru conduit.  But I
> would like a clean way to support the 70' of cable going up to the top of my
> DX-70 telescoping tower.
> 
> The question is if it is bad form to put more than one cable into the grip.
> I understand that the braid will not fully contact any one cable.  The only
> reason to consider mor than one per grip is that they seem to cost over $30
> each.
> 
> Any alternate common method to support cables would be appreciated.  I
> suppose good tape on top section is always an option.  Using one RG217, one
> rotator cable and one 24 conductor for DB36 control.
> 
> Thanks.
> 
> Al
> 
> N6TA
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>