[TowerTalk] Wireman W2DU Current Type Balun

[Máximo EA1DDO_HK1H]

Paul, there is a document somewhere showing S21 better (more accurate) results to S11.
I need to look for that doc.

73,

Máximo EA1DDO
www.EA1DDO.es





 





-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of Paul Christensen
Sent: domingo, 25 de diciembre de 2022 8:03
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Wireman W2DU Current Type Balun

Jim (K9YC),

When making Rs measurements are you using the S11 or S21 method?  Steve, G3TXQ was an advocate of S21 while Owen, VK2OMD claims S11 results in better accuracy with high Rs values.

I've been using S21 with G3TXQ's VNA adapter on a PC board.  It's shown at the bottom of the page in the link below:

http://www.karinya.net/g3txq/chokes/

Paul, W9AC


-----Original Message-----
From: TowerTalk <towertalk-bounces at contesting.com> On Behalf Of Jim Brown
Sent: Saturday, December 24, 2022 10:29 PM
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Wireman W2DU Current Type Balun

On 12/24/2022 6:47 PM, Jim W7RY wrote:
> The 1:1 shown is exactly the same as Balun Designs. Except for the
housing.

Do you know that it's the same ferrite mix? That makes a huge difference, and #31 the only one I've found that yields REPEATABLY good high Rs values at HF. #43 and #52, which can provide high enough values, but they are much higher Q than #31, so the wide mfg tolerances of all ferrite cores causes every one to be different.

73, Jim K9YC


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk