[TowerTalk] Taper conversions ...

[Stan Stockton]

I believe the best way is to determine the resonant frequency of each element using AutoEZ and then adjust the tips of you actual taper schedule/element to match the original antennas.  If I remember correctly AutoEZ will do that automatically with the press if a key.  While you are at it when you have completed that task you might as well optimize the design also using AutoEZ.  Not required but perhaps slightly better if you have NEC-4.

Stan, K5GO

Sent from my iPhone

> On Jul 30, 2022, at 8:08 AM, Richard Thorne <rthorne at rthorne.net> wrote:
> 
> Good find John,
> 
> I've been studying K8CU's log periodic project. I'm toying around with the idea of experimenting/building a Log to go on my 78' tower.  I've always wanted to try one.  I have a pair of M2 10-30LP8's and I'll need to look at the tapers as K8CU uses different element sizes than M2 does.
> 
> Rich - N5ZC
> 
>> On 7/29/2022 9:31 PM, john at kk9a.com wrote:
>> Perhaps Element can be downloaded here:
>> http://www.realhamradio.com/Download.htm
>> John KK9A
>> Joe Subich, W4TV wrote:
>> Where is Leeson's workbook available?
>> 73,
>>     ... Joe, W4TV
>> _______________________________________________
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk