[TowerTalk] Rohn 65G Accessories

[Grant Saviers]

DIY plasma cutters that easily cut 1/4" are ridiculously cheap, and easy 
to use.  I make a pattern in plywood with offset enough to compensate 
for the kerf to torch edge.  Clamp the top plate to a tower section and 
mark the bolt holes for drilling.

Grant KZ1W



On 3/25/2022 12:05, john at kk9a.com wrote:
> Perhaps K7PN or K0XG can make those components for you. I worked in
> manufacturing so I was able to make the plates for my Rohn 65 tower myself.
> If you can draw them with a CAD system it should not be difficult to find a
> local place with a laser or water jet to cut out the plates. Getting them
> galvanized is easy.
> 
> GL,
> John KK9A - PJ4R this weekend.
> 
> 
> 
> Byron W5FH wrote:
> 
> Anyone know where to obtain rotor and bearing shelves for the 65G
> tower?Thanks, Byron W5FH
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk