[TowerTalk] Exothermic welding mold

[David Gilbert]

It might be possible to modify those 5/8" ceramic molds (maybe by using 
a grinder bit in a Dremel) to handle a 3/4" rod and three #2 wires, but 
I doubt it would work very well.  Not enough room left over for enough 
powder to properly heat all of that mass.

Dave   AB7E


On 8/13/2023 9:49 AM, Dave (NK7Z) wrote:
> https://www.kf7p.com/KF7P/HargerUniShot.html
>
> 73, and thanks,
> Dave (NK7Z)
> https://www.nk7z.net
> ARRL Volunteer Examiner
> ARRL Technical Specialist, RFI
> ARRL Asst. Director, NW Division, Technical Resources

>
> On 8/13/23 07:42, Martin A. Flynn wrote:
>> Looking for a mold that can be used to connect three (3) 2/0 
>> concentric copper cables to a 3/4 Inch copper clad rod.
>>
>> Does this exist?
>>
>> 73 Martin Flynn
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk