[TowerTalk] Tower Tilt-Over Ca 1. Tower Tilt-Over Cable Attachment (Drew Vonada-Smith)ble Attachment (Drew Vonada-Smith)

[marko.n5zo at gmail.com]

Did you figure this out ?
I just worked on that tower with tilt fixture myself last week (1st time
too).
There is small sling that wraps around tower leg and connects with bolt to
end of winch cable and thimble on it.
I will send you picture of it.
73 de Marko N5ZO



----------------------------------------------------------------------

Message: 1
Date: Sat, 13 Apr 2024 19:40:59 +0000
From: Drew Vonada-Smith <drew at whisperingwoods.org>
To: "towertalk at contesting.com" <towertalk at contesting.com>
Subject: [TowerTalk] Tower Tilt-Over Cable Attachment
Message-ID:
	
<MN2PR18MB36084331C20010AED6B57CD4C80B2 at MN2PR18MB3608.namprd18.prod.outlook.
com>
	
Content-Type: text/plain; charset="iso-8859-1"

I am installing a used crank-up/tilt-over tower, an older Tashjian model.
My next step is to finish the tilt-over mechanism and place it all on the
already poured foundation.  I have replaced the tilt winch and pulley
mounted on the raising fixture, but there is no cable attachment point
present to attach the cable to the tower leg (about 8 ft high, per the
diagram).

What is the correct method/type of hardware to attach the tilt-over cable to
the bottom section tower leg?  Obviously, it must allow room for the
sections to nest.

73,
Drew K3PA

________________________________



------------------------------

Subject: Digest Footer

_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


------------------------------

End of TowerTalk Digest, Vol 256, Issue 10
******************************************