[TowerTalk] Mast material question

[john simmons]

Mark,

DXEngineering has a mast load calculator (offline as of this moment). Although I'm not answering your question directly, many here will have a good 'seat of the pants' feeling if you tell us what antennas and what heights you are planning for.

73
-de "Curly" John NI0K
QRZ.com<https://www.qrz.com/db/ni0k>
Hamshack Hotline<https://hamshackhotline.com/> call me: 6100000271

On 5/28/2024 8:39 AM, Mpridesti via TowerTalk wrote:

Looking to purchase a mast that was quoted as:

CRT 2 inch OD x 0.25 wall by 20 ft DOM

Not galvanized as yet.

Will this be near equivalent to Chromoly?

A modest antenna load is planned- wind surface area.

Regards,

Mark, K1RX


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com<mailto:TowerTalk at contesting.com>
http://lists.contesting.com/mailman/listinfo/towertalk