[TowerTalk] Hy-Gail TailTwister plug pinout

Dave KØEKL k0ekl at outlook.com
Sun Sep 1 11:23:33 EDT 2024


Is this what you're looking for?

Ham2/3/4/T2x internal wiring:

#1 large black, small black, brown   	---> BLACK 	--GND & SOLENOID
#2 large yellow				---> WHITE	--SOLENOID
#3 green 				---> GREEN	--POT (+)
#4 blue 					---> BLUE	--MOTOR
#5 orange 				---> ORANGE	--R LIMIT & MOTOR-MID
#6 small yellow 			-	--> YELLOW	--L LIMIT
#7 white 				---> BROWN	--POT (-)
#8 red 					---> RED	--MOTOR

Source: Craig at C.A.T.S - rotor-doc.com



-----Original Message-----
From: TowerTalk <towertalk-bounces at contesting.com> On Behalf Of n5xz at earthlink.net
Sent: Friday, August 30, 2024 4:23 PM
To: towertalk at contesting.com
Subject: [TowerTalk] Hy-Gail TailTwister plug pinout

I recently purchased an unused TailTwister rotator for $20(!). I have been using T2X's rebuilt by Norm's (I think) where the original terminal strip was replaced by a plug/socket. I am 'assuming' they are wired the same but I don't have a pinout to confirm before I connect the old plug to the new socket. Does someone have a pinout I can use to compare and double check first? It is in a 'current' manual...I only have an old manual before the plug...

Thanks,

Allen R. Brier N5XZ
1515 Windloch Lane
Richmond, TX 77406
713-705-4801



--
This email has been checked for viruses by AVG antivirus software.
www.avg.com

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk



More information about the TowerTalk mailing list