[TowerTalk] RT-20 settings for Yaesu G-2800

[n5xz at earthlink.net]

Currently setup is:
Offset = 180
Delays = 3
Min Speed = 5
Max Speed = 6
CCW Limit = 184 (could adjust to 180)
CW Limit = 175 (could adjust to 180)
Option = Yaesu
Knob Time = 40
Mode = Normal
Ramp = 3
Bright = 8

Would appreciate any comments.

73/161,

Allen R. Brier N5XZ
1515 Windloch Lane
Richmond, TX 77406 USA
713-705-4801

-----Original Message-----
From: Mpridesti <mpridesti at yahoo.com> 
Sent: Sunday, April 13, 2025 11:36 AM
To: n5xz at earthlink.net
Subject: Re: [TowerTalk] RT-20 settings for Yaesu G-2800

Yaesu’s original line of rotors were AC motors then switched over to DC. 

Regards,

Mark, K1RX


> On Apr 13, 2025, at 12:33 PM, n5xz at earthlink.net wrote:
> 
> Hi, I'm trying to setup a Green Heron RT-20 for a Yaesu G-2800 
> rotator.  As part of the setup, I noticed a Max Speed parameter = AC MOTOR (Value = 11).
> The Yaesu is a DC motor. Why is AC MOTOR one of the parameters?
> 
> 
> 
> If someone has a complete setup for the RT-20 (not sure if the RT-21 
> is different), I sure would appreciate it.
> 
> 
> 
> Thanks,
> 
> 
> 
> 73/161,
> 
> 
> 
> Allen R. Brier N5XZ
> 
> 1515 Windloch Lane
> 
> Richmond, TX 77406 USA
> 
> 713-705-4801
> 
> 
> 
> 
> 
> 
> 
> --
> This email has been checked for viruses by AVG antivirus software.
> www.avg.com
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk



-- 
This email has been checked for viruses by AVG antivirus software.
www.avg.com