[TowerTalk] Separating Aluminum Boom Sections

[J. Hunt]

 Heat and cool the joint... thermal expansion and constriction.. 
PB Blast may also help.  

Thanks n 73,JamesKI5DQ
    On Sunday, March 23, 2025 at 06:53:15 PM CDT, Bill Eisinger <bill at theeisingers.com> wrote:  
 
 Hello- I'm trying to pull apart two sections of an antenna 3" aluminum boom...each section is 18' long so the total length is 36' which makes it a bit unwieldly obviously. The antenna was in the air for 25+ years and the boom pieces have managed to weld themselves together.

Anybody have any ideas how to separate them?...I've tried heat, banging on it, etc, etc...because of the size there's no easy way to clamp one end that I can figure out. I've seen tools for separating muffler pipes but nothing for 3".

Any suggestions appreciated.

73's
Bill, AA7X
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk