I've been through the archives on this but have not found

suitable answers.


In addition to some Cadweld "one-shots," circumstances require

me to clamp / braze some less critical connections.


I've some skill welding and brazing and an oxy-fuel setup.


1    Is there a specific flux that is required or just works

      better for this procedure?  If so, a maker and part 
     
      number would be appreciated.


2    Is there a specific type of brazing rod that is required

      or just works better for this.  I asked my welding jobber

      for "silver bearing" brazing rod and got a blank stare in

      response.  If so, a maker and part number would be

      appreciated. 


3    I'll be using stranded #2.  Any special precautions, advice

     or "tricks of the trade" would be welcomed. 


Thanks to all.

73

Tim Colbert  K3HX




________________________________________________________________________
Try Juno Platinum for Free! Then, only $9.95/month!
Unlimited Internet Access with 1GB of Email Storage.
Visit http://www.juno.com/value to sign up today!