First to measure the impedance of the home brew open wire feeder. Then measure the antenna impedance when at its final operating position/height. Finally to use stub matching on the open wire to match to the balun (whatever ration is required) and then coax back to the shack.

On Tue, 09/03/2019 08:05 AM, Wes <wes_n7ws@triconet.org> wrote:
> 
What parameter(s) are you trying to measure?  Why?
> 
> Wes  N7WS
> 
> 
> On 9/3/2019 4:23 AM, Neal Sulmeyer wrote:
> > How do I make measurements on open wire feedline with my analyzer? I have a RigExpert which has four discrete impedance settings (25,50,75, and 100 ohm). Obviously, the connection is for unbalanced (coax) lines.  A 4:1 balun would work with window line (440 ohm), but what about open wire 600 ohm?Email sent using Axigen Free Mail Server:
> > http://www.axigen.com/mail-server/free
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> >
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

Email sent using Axigen Free Mail Server:
http://www.axigen.com/mail-server/free