[TRLog] WAE QTC in multy configuration

[Igor Sokolov]

I did not get any reply so I assume the message did not make it to the
reflector (apparently my provider had some problems). Therefore I am
posting that again. I know Tree is very busy now preparing the next
version of the program but may be someone else can comment.

>1. In WAE contest while working multy single we have noticed that QTC
>sent from one comp are not sort of registed in the other one. That is
>although half of the available qtc were sent from one computer still the
>other one kept giving us a message something like " low on QTC memory,
>please send some QTC"  We had to copy couple of files from one computer
>to another to stop that. That  also breakes our strategy to give out QTC
>only when the rate goes down below  some predetermined limit. This time
>the program forced us to give out QTC whenever the number of QSO was
>high enough. That affected the rate to some extend because it happend
>sometimes during pile up.  Can this be fixed?
>2. In multy configuration when the foot switch used in normal mode (that
>is TX-RX switching) does one computer blocks the other one in Multy
>single or is it something that should be done through the hardware?
>I mean, if I press the footswitch connected to one computer does this
>action inhibit the TX on the other computer in M/S category?

--
Best regards,
Igor Sokolov,  UA9CDC , (N3TOD)
E-mail: igor@sokol.pssr.e-burg.su
Phone/Fax: 3432 229621


--
FAQ on WWW:               http://www.contesting.com/trlogfaq.html
Submissions:              trlog@contesting.com
Administrative requests:  trlog-REQUEST@contesting.com
Problems:                 owner-trlog@contesting.com
Feature Wishlist:	  http://web.jzap.com/n6tr/trwish.html