[TRLog] FT-920

[jcullum]

>From the 920 manual it seemed like you could have TR access the CW memories,
but it didn't seem like the SSB memories were accessible through the CAT
system.  In TR, you can embed the CAT commands in a function key definition
(i.e. F1, F2, etc.)  You'll have to look through the manual or the reflector
archives to find out the right procedure (can't remember off the top of my
head).

Good Luck, Jim K7MK.

-----Original Message-----
From: Wade Bates [mailto:ve3wib@hawknet.ca]
Sent: Thursday, August 10, 2000 7:06 PM
To: trlog@contesting.com
Subject: [TRLog] FT-920


Has anyone been able to access the Cat System on the FT920 keyer
commands, using TR or any other software.
I would like to be able to access the voice keyer in the 920 from the
computer. This involves pushing the play key then any numbered key from
1 to 4 . The manual gives the codes for this.
The code should be as follows 1b 01 00 xx 70h. Any ideas?
Thanks Wade VE3WIB

--
FAQ on WWW:               http://www.contesting.com/FAQ/trlog
Submissions:              trlog@contesting.com
Administrative requests:  trlog-REQUEST@contesting.com
Problems:                 owner-trlog@contesting.com
Feature Wishlist:	  http://web.jzap.com/n6tr/trwish.html