[TRLog] NAQP config

[Ron K6KYJ]

In setting up my config file for the NAQP contest this weekend, I noticed that I was not prompted for the NAME and QTH parameters.  These were included in my INPUT CONFIG FILE but the software did not pick them up.  I relocated that line to just above the CONTEST NAME and all worked well.  I have always had the INPUT CONFIG FILE line after the CONTEST NAME w/o any problem.

QUESTION:   I am able to set up my CQ QSL message to send    TU <name>  thereby confirming good copy of the name sent. However, in my S&P EXCHANGE, I used the same protocol and it does not pick up the name entered when I copied the initial exchange.  I presume this info has alread been flushed out by the time I hit the ENTER key.  Is there a way around this?


=*=* ==*=    =** =**=    =** *    =*= =**** =*= =*== *===
                Ron Angle, Chico CA     
     73 de K6KYJ  [From the Land of the Seven Dipoles]


--
FAQ on WWW:               http://www.contesting.com/FAQ/trlog
Submissions:              trlog@contesting.com
Administrative requests:  trlog-REQUEST@contesting.com
Problems:                 owner-trlog@contesting.com
Feature Wishlist:	  http://web.jzap.com/n6tr/trwish.html