[Trlog] QSO renumbering with POST.exe

[Charlie Ocker]

alan.kaul at att.net wrote:
> When I attempt to us POST.exe (unpacked with version  all677.zip), it  dumps out with the 
> message:   runtime error 209 at 06BI:000B.  So I tried an older version of POST.EXE and 
> POST.OVR dated 8/31/03, 16:33, (I think it was with all674.zip) and tried it again.  This 
> version of POST will compile logs, make Cabrillo file, etc., but it won't re-number the QSO's (I 
> use the CTRL-J option that enables me to log the actual frequency).
> 
> WHEN I TRIED TO STRIP OUT THE FREQUENCY DATA AND RENUMBER THE QSOS 
> (using POST/Log Procedures/clicking on C/then answering the third question prompt 
> RENUMBER QSOs? with Y) it appears to have made no changes in the .DAT file.  i.e. It 
> retained the frequency data (decimal point plus three digits) AND DID NOT NUMBER ANY OF 
> THE QSO's.
> 
> The log is from the PENNSYLVANIA QSO Party and is due on the 15th.  I've got just under 
> 100 QSO's but I'd rather not have to renumber them manually if I can avoid it.  Any ideas? 
> 
> Thanks and 73 de alan

I used 6.74 in SS and enabled frequency logging.  POST LC worked fine. 
Remember, the output file of this POST run is *NOT* log.dat, but 
something like LBOTHALL.dat.  You'll need to rename log.dat to something 
else (I use logfreq.dat) and rename the output of POST to log.dat.

73,
Charlie  N9CO