[UK-CONTEST] RSGB 80m CW Club Sprint

[Paul O'Kane]

The RSGB CW Club Sprint takes this evening, Wednesday
10th October, from 2000 - 2100 Local Time (BST) on 80m,
3520-3570, with a slow-speed CW section around 3560.

There are QRP (10w) and LP (100w) sections.  HP is not
permitted.

Rules at www.rsgbcc.org/hf/rules/2012/rsprint.shtml

SD V16.04 is free and unrestricted in this event.  You
can get it from www.ei5di.com.  If you don't have a key
file for SD, it will start in DEMO mode.  Don't worry,
once you select the RSGB Sprint, it will be unrestricted,

The Sprint has a specific QSO format, depending on
whether you are being called, or are the calling station.
If you use any QSO format other than the recommended one,
you will confuse potential callers and may lose QSOs.

Check the "Example CW QSOs" at
www.rsgbcc.org/hf/information/sprintQSO.shtml

When you have started SD, and entered a name for the
contest, you will see a table of all the events
supported.  Use Page Down to get to the second page,
then

   Select SD's "RSGB 80m Sprint" template.

Enter Mode as CW, and your Name for the exchange.
Set the band to 80m if you're not using rig control,
with the 80M or B80 commands.

UK entrants work everyone.  Exchange Serial + Name
No reports are exchanged.

It's easier to log the serial and name as a single
field in SD.  For example, SD expands "4FRED" to
"004 FRED" when you press Enter.

Following any QSO where you called CQ or QRZ, you
must QSY at least 2 kHz before calling another
station or calling CQ.

When you use SD's internal keyer, or an integrated
keyer such as WinKey, the appropriate exchanges
are hard-coded in the recommended format - you
can't change them.

Using ESM (Enter Sends Message) SD toggles between
"RUN" and "S&P" modes, and sends the exchange in
the recommended format.

Please experiment with a test file in advance.

After the contest, upload your Cabrillo log, from
SDCHECK, to www.rsgbcc.org/cgi-bin/hfenter.pl

Any problems, please ask at sd-user at contesting.com

73,
Paul EI5DI