[VHFcontesting] For Sale: Tower, Rotor, Mast and Accessories

[Ed Kucharski]

The Rotator has been sold!  
The tower with accessories and mast are still available.

AN Wireless HD-60, 60 foot heavy duty self supporting tower (see:http://www.anwireless.com/formore info, specs and present prices).
2 Rotor Mounting Plates and 1 Thrust Bearing Plate (drilled for a Peer 2 in., 2 hole, flange bearing) in the top section.
1 60 ft. Safety Lifeline System with DBI-SALA Safety Sleeve and Carabiner
1 Full set of Step Bolts.
The tower is on the ground in 6 x 10ft. sections and ready for sale/pickup. Photos available upon request for serious inquiries only.
$2100. Pick-up (only) at my Westminster, MD QTH.
Requires a 5 foot concrete base section (available from manufacturer) and appropriate base.

I do have a 4130 Chrome Moly ~22 foot, 2 inch OD, 1/4 inch wall Mast available (sold separately ($200) or could bundle with the HD-60 Tower for a total of $2250).
This tower can be converted into an 80 foot HHD-80 (Heavy-Heavy Duty Tower) by adding 2 HHD sections to the bottom and HHD concrete base section (all available from manufacturer).

73,
Ed K3DNE

> On April 7, 2018 at 4:15 PM Ed Kucharski <k3dne at comcast.net> wrote:
> 
> 
> I am preparing for a retirement move and am offering for-sale the tower system that supported my vhf-uhf-microwave antennas for the past 15 years:
> 
> 
> I prefer to sell as a complete package:
> AN Wireless HD60 60 foot self supporting tower (see: http://www.anwireless.com/for more info, specs and present prices)
> 2 Rotor Mounting Plates (1 drilled for Prosistel PST-71/61)
> 1 Thrust Bearing Plate (drilled for a Peer 2 in., 2 hole, flange bearing)
> 1 60 ft. Safety Lifeline System with DBI-SALA Safety Sleeve and Carabiner
> 1 Full set of Step Bolts
> 1 Chrome-Molly 4130, - 2 inch OD, 1/4 inch wall - ~22ft. mast
> 1 Prosistel PST-71 Rotor with original D controller and an extra controller (type B from a previous PST61 - I'm unsure of compatibility with the PST71 and extra rotor to mast bracket), hardware and approximately 130 ft. of rotor cable.
> 
> The tower is on the ground in 6 x 10 foot sections. The tower will require a 5 foot concrete base section and appropriate base.  2 additional HHD sections can be added to the bottom of this tower
> if additional height is desired to make an HHD80 (base and HHD sections available separately from the manufacturer).
> 
> 
> Photos available as are references on the condition of the tower from the climber/rigger who assisted in removal and disassembly for serious inquiries.
> 
> 
> $3650 for all. Pick up (only) required from my Westminster,MD QTH.
> 
> 
> 73,
> 
> Ed K3DNE
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting at contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting