[WriteLog] Audio recording on 1000MP

[Nick Lekic]

Hi Andy and all others who replied.

You were right.   I didn't get the monitor audio from 1000MP rear Af Out jack
because I was using mono jack on the cable.   Once I replaced cable mono jacks
with stereo all works as it should.

Now, when I record the audio by using Af Out jack on 1000MP,  Writelog will
record as following:
    In RX mode - main rx audio is recorded on the left channel and sub rx audio
on the right channel.
    In TX mode - left channel is silent and monitor audio is recorded on the
right channel.

When I use Writelog's Audio Review to listen to the recording I hear Main RX
audio in the left ear and my monitor audio (either in CW and SSB mode) in the
right ear.  I find this a bit annoying as the audio "jumps" between channels
(and my ears) every time I transmit but that is the way it is supposed to work.

Naturally if the Sub RX is engaged at any time,  RX audio is heard on the right
channel.

If  I use, say, front headphones output jack for recording, both Main and Sub
RX audio and monitor audio are mixed and recorded equally on both channels.  I
find this most convenient when using Writelog's Audio Review to listen to the
recorded audio.

Again, thanks to all who helped me with this.

73,  Nick

va3na

. Anders Larsson wrote:

> Hi Nick,
> You need a stereo connection from the Af Out jack to the sound board.
>
> The side tone on the MP will be recorded in WriteLog on the right channel
> and the main receiver signal on the left channel.
>
> You may need to check the Windows sound board settings on play back to make
> sure that the volume sliders are centered for stereo.
>
> Have fun
> 73
> Andy DF3IAL SM4CNN
>
> ----- Original Message -----
> From: "Nick Lekic" <va3na@rac.ca>
> To: <writelog@contesting.com>
> Sent: 01 July, 2001 15:31
> Subject: [WriteLog] Audio recording on 1000MP
>
> >
> > I am using Af Out rear jack on 1000MP to record audio with Writelog and
> > it works FB, but this jack doesn't provide my own CW monitor audio for
> > recording .   All I hear when I key the radio is some unreadable clicks.
> >
> > Monitor is turned on and I am using audio transformer.    Any clues?
> >
> > Nick
> > va3na
> >
> >
> > --
> > WWW:                      http://www.writelog.com/
> > Submissions:              writelog@contesting.com
> > Administrative requests:  writelog-REQUEST@contesting.com
> > Problems:                 owner-writelog@contesting.com
> >


--
WWW:                      http://www.writelog.com/
Submissions:              writelog@contesting.com
Administrative requests:  writelog-REQUEST@contesting.com
Problems:                 owner-writelog@contesting.com