[WriteLog] Interface

[Jim Kinser]

You can build a cable very easily using either of the two circuits 
described in the Writelog help under "Advanced Setup", "CW Interfacing".  I 
built the type using the 2N2222 but I know others who are using the opto 
isolator circuit.  Both seem to work fine, the opto isolator gives you 
better protection for your PC.  The cable interfaces with the TS570 by 
installing a 1/8 banana plug on the end of the cable and connecting it to 
the key jack on the back of the TS570.  Just buy a solder pin type LPT 
connector and backshell and you can build the circuit inside the backshell. 
 Works great!  I built one for each of my two rigs, and have then connected 
to two different LPT ports on the PC.  I can the change the port settings 
in Writelog to use either rig on CW.  If I still have the photo of the 
cables I built, I will e-mail them to you.
73
Jim N0AJ

-----Original Message-----
From:	ak0a [SMTP:ak0a@kc.rr.com]
Sent:	Wednesday, May 30, 2001 9:22 AM
To:	writelog@contesting.com
Subject:	[WriteLog] Interface


Thanks for all the replies. never thought about the LPT port for cw, now
where do I get a prewired cable??? TS570 to Laptop?


--
WWW:                      http://www.writelog.com/
Submissions:              writelog@contesting.com
Administrative requests:  writelog-REQUEST@contesting.com
Problems:                 owner-writelog@contesting.com

--
WWW:                      http://www.writelog.com/
Submissions:              writelog@contesting.com
Administrative requests:  writelog-REQUEST@contesting.com
Problems:                 owner-writelog@contesting.com