[WriteLog] CW Decoder

[Jerry Flanders]

The CW decoder is pretty slick, too. You have two decoders - try the one in 
the rttyrite window first.

Set TU-Type to afsk, then set Mode to cw. Tune in a machine-sent signal 
running at 25 - 35 WPM (It will not work with slow signals). Use the CW 
decoder visual display.

Make sure the decoder freq is set to the freq of your CW tones coming from 
your rig  - maybe 700 (near the "Rx" button in the CW decoder window).

Watch the signal peak (green line) and move it to the center line  by 
tuning rig to make sure the signal is positioned correctly.

Lower the upper limit code speed to about 40 if necessary. Lower can be 20. 
(See buttons at bottom of the CW decoder window).

You should see decoded CW show up on the rtyrite screen unless I left 
something out.

To set up to send CW, read up on the ports setup procedure.

You can read up on using the other decoder later.

Jerry W4UK

At 08:53 PM 1/13/2002 +0000, Major Ron wrote:
>OK gang,
>
>I now have evrything working in WL EXCEPT for the CW decoder. All I can get
>it to decode is gibberish. Any tips here? I've tried everything I could find
>in the 'HELP' files & at K9JY's site. Using V10.29E. Any help sincerely
>appreciated.
>
>I must say that, with the exception of the CW decoder, everything works as
>slick as a dream!
>
>Using paired rigs here. A TS-2000 & TS-850SAT as one pair, and two
>TS-850SAT's on the other pair. Computer is a HB 1.4GHz Athlon running
>WIN98SE. Rig(s) are on COM1 & COM 3 with RigBlaster Plus on COM2.
>
>Thanks & GL to all,
>Ron, KA9ALC