[WriteLog] port changes

[Bill Hurte]

McKay wrote:

>Hi guys
>I use WriteLog configured for Com port 1. The OS is Windows 98. Recently I
>downloaded MMTTY and in order to get another com port I installed a serial
>card with dual ports. Now, my ports show "5,6, and 7". When I called up
>WriteLog for the RAC contest there was no rig control. It was still set on
>Com 1 but apparently Com 1 has changed to something else.  Writelog only
>allows com 1 through 4 and my computer now only shows com 5,6 and 7. Any
>suggestions?
>Archie, K4GA
>
>
>_______________________________________________
>WriteLog mailing list
>WriteLog at contesting.com
>http://lists.contesting.com/mailman/listinfo/writelog
>WriteLog on the web:  http://www.writelog.com/
>
>  
>
Hi Archie,
Try adding the line CommSlot1=5 to your ini file under the [Ports] section.
I open my ini. file in 98se by clicking the Start |Run|type in writrlog.ini
and enter. This should open your writelog.ini file in notepad where you can
add the command. Be sure to save after you make your addition.
Take a look at www.k9jy.com for more information. Good luck.
Bill N8KM