[WriteLog] TS440S and WL

[Clive Whelan]

 Edfelter wrote:
> I read where the 440S runs at 4800 baud
> so changed that at the same time in WL
>

Virtually all Kenwood radios use 4800 baud. Simply setting 
Kenwood and auto in the relevant boxes is sufficient.



> Then I sent the frequency
> of the rig into WL via the Radio Button, but nothing happens.
>


Crucially, what is recorded in the frequency box in the WL entry 
screen? If this says "no rig !", then the interface is not 
communicating. If however it is simply recording e.g. 3500 or 
somesuch, you may need to execute Bands|Set frequency&mode and 
then select the appropriate COM port from the drop down menu.


This is the most common cause of failure to read frequency from 
the radio, and is a big gotcha that still trips me up.


73



Clive
GW3NJW