[WriteLog] ICOM

[Dave N4IG]

Hi Steve et all;

I have had the rig set to a different address
than the program, and the program would not 
talk to the rig via the COMM/CT17 until
the address in the rig agreed with the address
in the program. I found this out when I began
to configure DX4WIN and Writelog to talk to
the new IC 746 PRO. The Pro rig address default
is 66H and the old 746 default is 56H. Dx4win has
a 746 Pro setting so I used that in DX4WIN. Writelog
however; didn't have the Pro as selection and I selected
the 746 setting and writelog would not talk to the 
rig until I re-addressed the RIG. WA9ALS has mentioned
that the .INI file can be used to set the ICOM rig
address but the rig and the program must agree.

73 Dave N4IG



73 Dave N4IG