[WriteLog] Rigblaster Pro problems with Writelog

[Joe Stepansky]

Hopefully someone has experience with Rigblaster and can help me through 
this.

I've setting up my new Rigblaster Pro this morning, and decided to test it 
out with WriteLog.  I followed the Pro's setup instructions to the letter, 
and everything seemed to go well.  But nothing seems to work from either a 
CW or rig control standpoint (rig control under LogWindows doesn't work 
either, but if this gets solved I'm confident that one will too).

I have the Pro set up for FSK, PTT and CW on what they call Serial/Com A 
(connected to my COM1) and Rig Control on Serial/Com B (connected to my 
COM2).  Before I go on, rig control (using the external CT-17 interface on 
COM1) and CW keying (using my homebrew circuit on COM4) worked flawlessly 
during ARRL CW.

In the Ports window, I selected CW for COM1 (Rigblaster's COM A?) and Rig 
Control under COM2 (Com B?).  I put rig control under ComB because under 
ComA the IC-765 would key when opening up either LogWindows or 
WriteLog.....putting the rig on ComB solved THAT problem, but now nothing 
recognizes the rig.

Similarly, pressing F2 for what should be a contest CQ gives me nothing.

Anybody know what might be going on.  Again, I'm pretty certain all the 
jumpers are correctly set, since I've gone over them three times.  This is, 
as usual, probably something small and silly, but I'm not getting 
it.  Thanks for any assistance.

73, Joe KQ3F