[WriteLog] Writelog and Entrega Sixport Multiport Hub

[David Shipman]

I have a Entrega Sixport Multifunction USD Hub (2USB and 4Serial ports)
which worked fine on W98.  I then upgraded to W2000, at which point the
Hub disappeared of off the hardware list. As some of you may know,
Entrega as bought by Xircom which in turn was bought by Intel. I
downloaded a driver (pgwin2k.202.exe) from Intel which is unsupported
but did bring the Entrega hub back into the system. However, whenever I
run RTTY (I have a PK-232MBX on Com 3) I run into a problem. Opening the
RTTY window is ok and running RTTY is fine. But if I try to close the
RTTY window or try to change from PK-232 to a soundcard interface I
receive the following - " KMODE_EXCEPTION_NOT_HANDLED", this also points
to "etiserpd.sys" as to where the exception takes place. It appears that
the driver software is 'broke'
I would rather not buy a new hub if don't have to. 
If anybody has a software solution to this I appreciate the feedback.
 
Thanks - Dave
 
David Shipman (VE7CFD/VA7AM)
davidshipman at shaw.ca
Phone: 604-926-8170
Fax:      604-926-7320
http://www.bcdxc.org
 
All outgoing mail scanned by Norton Anti Virus