[WriteLog] CW keying on LPT1 with XP

[Jerry Flanders]

It went without any hitches for me a week ago also. Userport was easily 
installed and configured per the instructions. Note that a specific 
configuration for the exact port address on the PC is required. The default 
addresses shown as it starts up were NOT correct for my port.

Good luck.

Jerry W4UK

At 15:23 2/3/2005, jduerbusch at charter.net wrote:
>After reading there comments on the cw keying I decided to try it last 
>night.  I had recently upgraded to Win/XP from Win98SE and I had been 
>keying cw with WL on a comport.
>
>Looking at the Port setup on WL all the LPT ports where grayed out.  After 
>I ran the program Userport and re-booted I now have LPT1 and LPT3 open and 
>both work fine CW keying my rig.
>
>One note, the Writelog.ini file address for LPT1 ~ 3 need to be the same 
>as what Windows has listed.
>
>So bottomline is that it works fine.
>
>But my other problem is that in DXBase2005 I can't get it to send CW from 
>the LPT port, go figure??
>
>Joe K0BX