[WriteLog] Sound Card Setup for CW

[W7RY]

That's because you don't send CW with a sound card. CW is generated in
the radio.  Use a keying transistor from the serial port or the parallel
port.

You would not want to send audio tone from the sound card to the
microphone input on the rig. Why would you send CW using an audio tone
and the rig in SSB mode?


73
Jim W7RY


-----Original Message-----
From: writelog-bounces at contesting.com
[mailto:writelog-bounces at contesting.com] On Behalf Of Kevin der Kinderen
Sent: Saturday, November 05, 2005 6:13 AM
To: 'Kevin der Kinderen'; writelog at contesting.com
Subject: Re: [WriteLog] Sound Card Setup for CW

OK, found Soundboard Mixer Control as a separate program and can receive
CW.

Still cannot send CW via the soundcard.

Kevin - K4VD

Kevin der Kinderen
http://kj4qf.net/


> -----Original Message-----
> From: writelog-bounces at contesting.com [mailto:writelog-
> bounces at contesting.com] On Behalf Of Kevin der Kinderen
> Sent: Saturday, November 05, 2005 14:00
> To: writelog at contesting.com
> Subject: [WriteLog] Sound Card Setup for CW
> 
> I'm struggling to figure out how to set up my soundcard to send CW in
> writelog. I'm able to get it done in MixW and can run RTTY, etc.
> 
> 
> 
> In WriteLog I cannot figure out how tell Rttyrite which sound card to
use
> (I
> have three in this machine). The WriteLog CW Receiver window shows no
> signal
> and transmitting has no audio output.
> 
> 
> 
> Where do I tell WL to use a specific soundcard?
> 
> 
> 
> Kevin - K4VD
> 
> 
> 
> Kevin der Kinderen
> 
> http://kj4qf.net/
> 

_______________________________________________
WriteLog mailing list
WriteLog at contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/