[WriteLog] "Antenna to Azimuth" is gray. No Rotor control

Byron Lichtenwalner w3wkr at verizon.net
Sun Oct 30 21:06:18 EST 2005


Hi Michael

Here is my checklist for getting it working

Select serial port under port set up
Select rotor controller type

Open WL.ini and make sure there is a line there that defines the port
parameters  (e.g.  comx:=(baud rate, etc)

Open WL and click on Windows, the Beam heading.  Enter a prefix, and verify
you are getting a heading showing in the Beam Heading window.

Now you should have the select heading showing.

Good luck.

Byron, W3WKR
----- Original Message ----- 
From: <WG0M at aol.com>
To: <writelog at contesting.com>
Sent: Monday, October 31, 2005 8:18 PM
Subject: [WriteLog] "Antenna to Azimuth" is gray. No Rotor control


> I must have something turned off as this command used to work just  fine.
> Anyone have any ideas?  Rotor works fine in DX4WIN.
>
> Setup Comm port stuff just fine...........just need to get "Antenna to
This
> Azimuth" highlighted.
>
>
>
> Michael WG0M
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/



More information about the WriteLog mailing list