[WriteLog] Winkey in WL

[Alan Pounder]

Go to Setup, Ports. The column of check boxes next to the Com ports
available should be ticked to show which port the Winkey is conneted to. In
the box on the bottom just right of centre on the Port Setup page, select
K1EL Winkey for device to generate CW. Job done.

Alan M0DAL

-----Original Message-----
From: writelog-bounces at contesting.com
[mailto:writelog-bounces at contesting.com] On Behalf Of Clive Whelan
Sent: 30 September 2005 18:11
To: writelog at contesting.com
Subject: [WriteLog] Winkey in WL


Well I finally got my DXdoubler to work with WL by running userport, and all
the switching works FB. Also WL will key OK on the LPT port when computer
keying is selected, so obviously the driver is working OK. However Winkey is
not working despite having it selected in Ports etc. In fact I am at a loss
to see how it could, because there doesn't seem to be anywhere to tell WL
which COM port is controlling Winkey.

Anyone been there?


73


Clive
GW3NJW

_______________________________________________
WriteLog mailing list
WriteLog at contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

-- 
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.9/115 - Release Date: 29/09/2005
 

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.9/115 - Release Date: 29/09/2005