[WriteLog] CW Speed Setup

[Georgek5kg at aol.com]

In a message dated 9/30/2006 2:40:00 A.M. Eastern Daylight Time,  
w0raa at w0raa.com writes:

Can  somebody tell me how to set the speed of CW within WriteLog?  I go to  
Help, type in the Search Window "CW Speed Setup" and it goes to a heading that  
says CW SPeed Setup, but there is no text.  Surely there must be a way to  
adjust the speed in Writelog.  Any help would be  appreciated.

Thanks,

Dick
W0RAA



Go to SETUP I PORTS I CW SPEEDS.  This will bring up a table into  which you 
enter the CW speeds in words per minute (wpm).  From lowest to  highest speed, 
enter the speeds beginning at the top of the first column and  going down, 
then to the top of the second column and going down...continue thru  to the end 
of the fourth column.  
 
Here is an example:
 
Col 1 - 18, 20, 22, 24
Col 2 - 25, 26, 28, 29
Col 3 - 30, 31, 32, 33
Col 4 - 34, 36, 38, 40
 
The speed at the top of Col 3 - 30 wpm in the example above - is the  default 
speed that WL will boot up with.  
 
When using WL, you increment your CW speed by using the PAGE UP and PAGE  
DOWN keys.  Each increment of PAGE UP or PAGE DOWN moves the speed to  the next 
entry in the CW Speeds table.  
 
I find that for the speeds in the mid range in which I operate, 30 to 34  
wpm, I want the speeds to increment in 1 wpm increments.  Above and below  30 to 
34 wpm, I use increments of 2 wpm each.
 
I hope this helps.
 
73, Geo...
 
George  Wagner, K5KG
941-312-9420
941-400-1960  cell