[WriteLog] CW Speed Setup

[Gary Senesac AL9A]

Not sure why the CW Speed Setup page in the Help manual is blank, but here's 
the drill.

Go to Setup/Ports and look for the button on the lower right side of the 
screen that says 'CW Speeds'.  Click on that and a window will open with a 
4X4 table of various CW speeds.  Make any changes you want to the speeds tin 
the table and click OK.  Click OK on the Ports window to close it.  Now go 
to Setup and click on the last item in the list, Save Configuration.  This 
will save your CW speeds for the next time you start WL.  To change the CW 
speed during a contest press Page Up or Page Down.  This will select the 
next higher or lower speed you have set in the CW speed table.  Check the 
task bar at the bottom of the main WL window and you will see the CW WPM 
speed change with each key press.

Gary AL9A

----- Original Message ----- 
From: "Dick Thompson" <w0raa at w0raa.com>
To: "Writelog Reflector" <writelog at contesting.com>
Sent: September 29, 2006 10:32 PM
Subject: [WriteLog] CW Speed Setup


> Can somebody tell me how to set the speed of CW within WriteLog?  I go to 
> Help, type in the Search Window "CW Speed Setup" and it goes to a heading 
> that says CW SPeed Setup, but there is no text.  Surely there must be a 
> way to adjust the speed in Writelog.  Any help would be appreciated.
>
> Thanks,
>
> Dick
> W0RAA
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>