[WriteLog] Signal Link USB DVK

[Joe Subich, W4TV]

Disable PTT in WriteLog when using the Signal Link USB. 

Signal Link generates its own PTT using an internal "VOX" and that 
PTT must be applied to pin 9 of the ACC2 jack.  PTT on pin 9 will 
mute the microphone jack and enable input on pin 11 of ACC2.  If 
If the normal PTT (pin 13 of ACC2 or the Mic connector) or PTT by 
serial command (CommPTT) is used, the ACC2 input will be disabled 
and the microphone jack will be "hot." 

This applies to all Kenwood radios with the 13 pin ACC2. 

73, 

   ... Joe Subich, W4TV 
       microHAM America 
       http://www.microHAM-USA.com 
       http://groups.yahoo.com/group/microHAM 
       support at microham.com 
 



> -----Original Message-----
> From: writelog-bounces at contesting.com 
> [mailto:writelog-bounces at contesting.com] On Behalf Of Jamie 
> Dupree NS3T
> Sent: Tuesday, August 14, 2007 10:13 PM
> To: writelog at contesting.com
> Cc: Steve Forst
> Subject: [WriteLog] Signal Link USB DVK
> 
> 
> Steve - in the Setup|Ports menu, do you have CommPTT as yes or no
> for the com1 to the TS-2000?
> 
> Do you have "windows sound board" highlighted for the DVK?
> What about the wav file location?
> 
> Have you saved the settings in the ports menu and then re-started
> your computer?  
> 
> Just trying to think off the top of my head....
> 
> I have the same rig, but for my audio files, I just run them through
> the mic input in the front and not the acc plug on the back.
> 
> 73 Jamie NS3T
> http://www.radio-sport.net
> Your home for ham radio contest news
>