[WriteLog] writelog via kam standard tnc in clone mode

[ve2lx]

Hello to all
best wishes for christmas and new year

I added a TNC kam stdr to my pro3 recently for RTTY contests.

I was using writelog + mmtty but again decided to work with two different flat screens configuration.
Kam stdr as main and WL + MMTTY on clone in RTTYrite.

But there is a thing I do not like with WL transmit across the TNC...it put a steady tone (mark) (before) to start to TX (diddling the texte transmission after).
Wtih WL and MMTTY that tone is but much shorter and almost not eared (being so short)
In contests it is a time lost.
Can we reduce the time delay of (that TNC tone) in WL.ini file for he Kam TNC operation...?
Or can we remove it by WL.ini...?
To compare using WL and MMTTY that tone is shorter.
With MMTTY alone it is also shorter and same delay.

During the last rtty contest while listening other stations, I eared only few stations with a long mark tone like that before the rtty texte is sent, probably mean the use a TNC?
Can someone help me...
Using two screens with a TNC and WL + MMTTY clone window (2 different units demodulating the same signal and texte sent) is very often helpfull to see calls end letters errors particulary in contests where speed is major.

If I can not ameliorate that situation i'll reconnect WL + MMTTY + rigbalster direct to the radio ACC 1 connector and then feed RADIO AUDIO to TNC AND to COMPUTER PORT...but I would really prefer to save that work and connect as it is now KAM main and WL - MMTTY in clone qindow saving me to modify physical connections

Gilles   VE2LX    
ve2lx at sympatico.ca