[WriteLog] wl and mmtty

[Charles Morrison]

The biggest question back to you is what type of interface are you using?  

FSK with MMTTY is selected on RttyWrite's ports tab.  The settings inside of
MMTTY are relevant in that you'll need to set a com port of something thus
allowing you to select COM-TXD (FSK) on the TX Tab.

Suggestions:

1.  Use a full blown copy of MMTTY, installed into another directory,
separate from the one you may use for daily operation.  Don't use the
"engine".
2.  In the Options/Setup MMTTY, click the TX Tab, in the PTT, click the port
that you're going to use for FSK.  In the Radio Command, make sure nothing
else is selected (Port Definition, etc).  Click the Misc tab and select
Com-TXD (FSK).
3.  Set your FSK port in RttyWrite's PORTS settings to the same one in 2.
4.  Selection the Option, Setup in MMTTY, click the TX tab and make sure
COM-TXD (FSK) is selected.



> Date: Sun, 5 Oct 2008 16:15:37 GMT
> From: "k2mme at juno.com" <k2mme at juno.com>
> Subject: [WriteLog] wl and mmtty
> To: writelog at contesting.com
> Message-ID: <20081005.121537.25381.2 at webmail08.vgs.untd.com>
> Content-Type: text/plain; charset=ISO-8859-1
> 
> Hi
> I have been pursuing this problem through the mmtty reflector but now take
the
> problem here.
> I am unable to get fsk keying using mmtty and wl. MMtty works ok as a
> standalone and I have tried all  suggestions from mmtty members so now
look
> for it to be a problem with the setup of WLog.
> Am using DTR for fsk keying and RTS for ptt. Any guesses as to the
probelm?
> Howie K2MME
>