[WriteLog] FT-990 Rig Control

[Arthur Bard]

Thanks Joe, so how do I get WriteLog to step in 10Hz steps ?

The FT-990 in default is stepping in 10Hz steps unless I keep my finger on the FAST button then it steps in 100Hz steps.

Regards Arthur G1XKZ




________________________________

The question is how Writelog does the mousewheel tuning vs. 
any other program.  The FT-990 command set has only one 
"step operating frequency" option (Up or Down).  The step 
size is set by the "fast" switch (10 Hz for slow, 100 Hz 
for fast).  

If WriteLog is using the "Step operating frequency" command 
those steps will be fixed based on the "Fast" switch.  On 
the other hand, DXLab does its mousewheel tuning by sending 
a specific new frequency (tune to F(new) where F(new) = 
Step + F(old)).  

73, 

   ... Joe, W4TV 

> 
> There is only one instance of the writelog.ini file on the PC 
> and it is in the windows directory.  Here is the section with 
> the MOUSE settings.....
> 
> [PORTS]
> dvkechomic=1
> dvkstoploop=1
> dvktype=1
> dvkport=4
> cwtype=1
> cwport=1
> CWPTTCONTROL=0
> CWPTTDELAY=0
> Comm2Used=USED,POLL,19 
> Comm2RigManager={D0DE9422-0517-11D4-9D1B-00105AA43DDF}
> Comm2XmitControl=NEVER
> MOUSE_WHEEL_HZ=1
> [RTTYRITE]
> 
> PC
> was re-booted loaded WriteLog and tested still 100Hz 
> increments then closed WriteLog and opened the ini file and 
> copied the bit above. Very strange. Using XP Pro SP3
> 
> Regards Arthur. G1XKZ