[WriteLog] SIIG 4 Serial Port PCI Board and MMTTY

[Eric - VE3GSI]

Al,

The only time I have seen a problem of crashing the PC with FSK on a serial
port, if, and only if I had accidently choose a PK-232 Modem and configured
it to a virtual serial port. 

You can check MMTTY by running it as a stand-alone on the suspect port, this
might verify it is WL setup problem.

Also double check for new SIIG site for new drivers and any FAQ's.

73 Eric - VE3GSI
 



> -----Original Message-----
> From: Aldewey at aol.com
> Subject: [WriteLog] SIIG 4 Serial Port PCI Board and MMTTY
> 
> I am having trouble getting my new SIIG  PCI 4 Serial Port board to key
> FSK.
> 
> I have a PC with one built in Serial Port.  The built in serial port
> (at
> COM 1) keys FSK  no problem.
> 
> When I install the SIIG board, it adds COM 5, 6, 7, and 8.
> 
> I use COM 5 and 6 for Rig control with no problem.  However, if I
> select
> COM 7 or 8 to key FSK in MMTTY, my PC crashes and immediately re-boots.
> I
> temporarily took the radio off of COM 5 and 6 and tried those for FSK -
> same
> result.  No matter what port I chose on the SIIG board, selecting it to
> key
> FSK crashed my computer.  It crashes as soon as I make the selection in
> RTTY
> 
> Operating System is XP.
> 
> Has anyone run into this issue?  Any suggestions on what I might try?
> 
> 73,
> 
> Al, K0AD