[WriteLog] WKUSB & WriteLog
gl1800winger at verizon.net
Thu Nov 1 17:34:35 EDT 2012
I'm not sure why your WKUSB is set to COM 8 - as a USB device it shouldn't
have a serial port assigned.
Just set Set-Up/Ports... Keyer pull-down to K1EL Winkey (not Winkey 2) and
it should work (at least it does on mine).
Tom Shelton, AB3IC
Always be yourself...
Unless you can be a Unicorn...
Then always be a Unicorn...
From: Noel Zeibari
Sent: Thursday, November 01, 2012 5:13 PM
To: writelog at contesting.com
Subject: Re: [WriteLog] WKUSB & WriteLog
Thanks for the reply. Yes I'm familiar with the keyer function
to be off.
Ron N0AT, I tried your suggestion,it didn't work.
when I start WL I have no problem sending CW with the bencher
thru WKUSB, the problem is when I use any of the canned messages
they key the rig and it sounds like PACTOR signal exactly and not a CW tone.
Jim N7US, I never had an entry in the WL .ini about the WKUSB.
So, I copied your setup into the .ini file & rebooted the PC.
The only thing I changed was the paddleswap from 1 to 0 I use
my left hand sending CW. See the above note to Ron.
What puzzles me is that all the other programs like N1MM, DX4WIN, MIXW and
N3FJP work great. Hope some one can help before this weekends SS contest.
73, Noel (OM) N3NZ
----- Original Message -----
From: "Hal Kennedy" <halken at comcast.net>
To: "'Noel Zeibari'" <n3nz at n3nz.com>
Sent: Thursday, November 01, 2012 11:57 AM
Subject: RE: [WriteLog] WKUSB & WriteLog
> Make sure the keyer function in that 897D is turned OFF.
> -----Original Message-----
> From: WriteLog [mailto:writelog-bounces at contesting.com] On Behalf Of Noel
> Sent: Thursday, November 01, 2012 9:59 AM
> To: writelog at contesting.com
> Subject: [WriteLog] WKUSB & WriteLog
> Hi All,
> I assembled WKUSB few months ago, it is working flawlessly with MixW,
> DX4Win, N1MM and
> N3FJP programs, the setup is intuitive no problems at all. However, with
> I've been struggling
> getting it to send canned CW, every time I push a button it sputters
> incoherent gibberish.
> Here is my setup:
> Rig is a Yeasu 897D
> Cat is on USB Com 7
> WKUSB on USB Com 8
> In WL CWPTT, tried On LPT, None [e.g. QSK], Command rig on Com port= Same
> I searched the archives for help, none helped.
> Can some one help me? What else I can change in the .ini file to get it
> I 've been using WL since 1997 with the simple CW interface cable, I just
> don't want to
> go back to it.
> 73, Noel (OM) N3NZ
> WriteLog mailing list
> WriteLog at contesting.com
> WriteLog on the web: http://www.writelog.com/
WriteLog mailing list
WriteLog at contesting.com
WriteLog on the web: http://www.writelog.com/
More information about the WriteLog