[WriteLog] 7600 & Writelog

[k0bx at arrl.net]

Sometimes this happens, here is something you can try, it has worked for me!

Using NotePad edit C:\Windows\writelog.ini, or whereever you INI file is 
located,   as follows: 

In the file, go to the section labeled [Ports]. 
Look at the line for the Com port you intend to use.  It will look like this: 
COM1:=9600,n,8,1,x 
Check to be sure all parameters are correct, then Delete the final x (but not 
the comma).  It should look like this: 
COM1:=9600,n,8,1, 
Click on File, Save.  Then open WriteLog;

Joe K0BX

 Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk) without 
my permission.




________________________________
From: "n3bm at finnsfield.net" <n3bm at finnsfield.net>
To: WriteLog at contesting.com
Sent: Wed, October 24, 2012 8:58:04 PM
Subject: [WriteLog] 7600 & Writelog

I'm snowed!

I bought a new IC-7600 today and installed it in the shaced and connected it to 
my PC. Everything works- MMTTY, MRP DXLab Suite - except WriteLog.  I'm using 
V11.07D and I don't think it's seeing the 7600.  I can't figure out how to enter 
the new hex address and I'm guessing that might be the problem.  I entered "Icom 
IC-7600=0x7A" in the .ini file but that didn't help.  


In WriteLog I'm not getting a frequency or band:  I't just shows "KHz LSB"  CW 
receive works which means the sound card is OK but there is no CW transmit and 
no RTTY.

I thought it might be possible that I needed the 7600 USB driver so I installed 
that.  No change.

I've Googled every possible combination of 7600 and WriteLog I could think off 
but haven't found anything that helps.  Can anyone help me figure this out?  


Thanks,

Aubrey N3BM
_______________________________________________
WriteLog mailing list
WriteLog at contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/