[WriteLog] SO2V operation with FlexRadiio 3000?

[Jerry Pixton]

Brian,

I have finally gotten my Flex 5000A to work with Writelog and a microHAM 
mk2R+ SO2R Controller for casual dxing on two bands.

It is not a contest-grade setup for RTTY with the 5000A because
of internal crosstalk between the two Receivers.

But the Flex 3000 only has 1 receiver doesn't it? So where is the 2nd 
VFO? Ah, the transmit VFO. So we are talking in-band use of the two 
VFOs?? As in SPLIT mode. I am just guessing since my Flex is the 5000.

You might take a look at the Elcraft K3 rig driver. It is very close to 
what you might want for in-band (run and multiplier setup) and allows 
two radios to be set up on the same port for CAT.

I have much information on my trials. I can get back to you after the 
WPX if you need.

Jerry, W6IHG

On 2/7/2013 9:42 PM, Brian Miller wrote:
> Hi all
>
> I'm exploring the feasibility of using WriteLog with PowerSDR and a
> FlexRadio 3000 transceiver. I have successfully connected Writelog with
> the radio using the Kenwood TS2000 CAT protocol. However, I don't seem
> to be able to configure the logging software to operate in SO2V mode. I
> can pull up the two band maps but there does appear to be any way of
> bringing up a second entry window (similar to what would be used in SO2R
> mode).
>
> Is it possible to configure WriteLog to operate a FlexRadio transceivers
> in SO2V mode?  If so then any advice on how to achieve this would be
> much appreciated.
>
> Thanks and 73
>
> Brian VK3MI ZL1AZE
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>

-- 
-----------------------------------------------
Dr. Jerry R. Pixton, PIXOS Designs
http://www.shentel.net/pixosdesigns/RadioTuner/
jpixton at shentel.net
-----------------------------------------------