[WriteLog] MK2R+ and Writelog 11.18c

[Richard Thorne]

This is a cross post to Writelog and Microham.

I've been working on configuring an MK2R+ SO2R controller with a pair of 
K3's and my Win 7 Pro computer.

I've been able to get SSB and CW to work properly.

I'm hung up on RTTY using MMTTY.  I've downloaded the setup guide from 
Microham and have setup two directories and two instances of MMTTY, I 
also have the MMTTY plug in for Writelog installed.

If I select the test button for FSK on the MK2R+ ports tab for rig 1 I 
get diddling same goes for rig 2.

While in Writelog I've followed the setup instructions by first 
selecting rig 1 and starting MMTTY from the appropriate directory, same 
for rig 2.  However, I can't get either to diddle.

In addition, both instances of MMTTY appear to be getting the same audio 
from rig 1 from the phone jack.  I've selected the right and left audio 
source on the misc tab while in TNC setup.

On the sound card tab in TNC setup I've selected Reception: Microphone 
(3 - USB Audio CODEC) and Transmission: Speakers (3 - USB Audio CODEC)

How does one determine which device identifier to select on the misc tab 
in tnc setup?  I thought it would be 3 but I'm obviously incorrect.  I 
want to to use the line out on the rear of the K3's to grab the audio 
since it's fixed and won't be affected by the volume control of either K3.

The frustrating part is that I had this MK2R+ working just fine on RTTY 
with one K3, adding the 2nd K3 has been a challenge.  Is there an 
updated setup guide specifically for Win 7?

I'm half tempted to dust off an XP Pro laptop and give that a try, Win 7 
makes things very challenging.

Thanks in advance for any assistance.

Rich - N5ZC